CSP 2010B Beta - no prototypes built

Since syncing the other day after the B-wing was added, I've not been able to get prototypes to build, although my directory names, profile choice etc remain unchanged.

- after sync, light was green

- after update to try to build prototypes, light is yellow

- on attempts, log usually says prototypes will NOT be built, whether the check box is checked or not

- if you run the update with the box unchecked, then run it again with it checked, the logs says "will be built" but still nothing appears

- unmodified example .cfg is in my GMWC_Prototypevehicles, with 2 other .cfg files of my editing

Noticed that this log has references to \rFactor\GameData\Vehicles\GridMotorsports\gmwc.csv even though this install is in my rfactor2 dir.

The core call does indeed try to do CSP (--csp flag).   3 CSP files were picked up (reading vehicle definitions from: vehicle_tmp.csv . . . loaded 3 vehicle entries).  The vehicle defs are coming from the wrong place...must be something lingering from copying rfactor directories, but the CSP vehicle def is relative and might be fine.

Still, the copy issue may be messing something up.  See if one of the config files has rFactor w/o the 2 in it, like autosave.cfg or something.

Yes - in autosave.cfg. Manual edit on that has given progress but not success

- The last three build block in the log seem to refer to the proto names I have (I see 2 have the same name - duh !)

- I'm getting some artefacts appearing with that name embedded. So a .ntc in chassis and a .hdv in package (search on files containing MRDC attached)

Autosave as it had been before editing is attached.

Looking at the files created/updated, I also have a nice vehicle_tmp.csv, which looks just the job

I think I might restart and give this another go.